The first ground connection goes into the first socket and connects to pin 19. By following these diagrams, we can make the following: pin connections. The next step is to start connecting the ground and power wires to the cluster. Then solder, the wires to the positive terminal on the DC Jack place, the heat shrink over the solder joint and apply heat.Īt this stage, we will have all the power connections ready on the DC Jack, with the five wires soldered to the negative terminal for the ground connections and six wires soldered on the positive terminal for the 12 volt power connections. At the other end of the wires cut off the connections with wire cutters strip, the ends of the wires and twist together, cut a piece of heat, shrink, tube and place it over the ends of the wires. For this, we will need six jumper wires with female ends.

The next step is to prepare the wires for the 12 volt positive power. At the other end of the wires cut off the connections with wire cutters and strip the ends next join the five wires by twisting the ends together, cut a small piece of heat, shrink, tube and place it over the ends of the wires connect, the wires and Solder, the ends to the negative terminal on the DC jack then slide the heat shrink over the solder joint and apply heat to shrink the tube. For this we will need 4 wires with female ends and one wire with a male end. For the wiring we’ll use Arduino jumper cables, which can plug directly to the pins on the back of the cluster to begin with, prepare 5 wires for the ground connections. Third, black socket has 12 pins numbered from 1 to 6 and 7 to 12. The second blue socket also has 26 pins numbered from 1 to 13 and 14 to 26. Has 26 pins? These are numbered from 1 to 13 and from 14 to 26.

There are three connection sockets that will be connecting the wiring to the first socket.

Virtronics simulator for arduino